Trip to Hudson Breaker

Forum rules
ATTN Coal Dealers: To advertise your company you're allowed to start one new topic in "Coal Prices, Coal Quality, Coal Dealer Inquiries and Reviews". You may also respond to other topics started by others where your company has been mentioned and are encouraged to do so. Any other posts just for advertising here or anywhere else on nepacrossroads.com will be considered spam and removed. Repeated violations will result in a permanent ban.

Re: Trip to Hudson Breaker

PostBy: SMITTY On: Thu Feb 04, 2010 12:04 pm

That would be a smart practice. I'll bet those huge dump trucks probably hold 8 gallons of oil in the crankcase! :lol: :o Not to mention hydraulic oil & gear lube -- they'd have plenty.
User avatar
SMITTY
Member
 
Posts: 8953
Joined: Sun Dec 11, 2005 1:43 pm
Location: West-Central Mass
Stove/Furnace Make: Harman
Stove/Furnace Model: Mark III

Visit Lehigh Anthracite

Re: Trip to Hudson Breaker

PostBy: New Hope Engineer On: Thu Feb 04, 2010 12:15 pm

how did your little toyota handle the weight?
User avatar
New Hope Engineer
Member
 
Posts: 447
Joined: Thu Aug 21, 2008 8:12 am
Location: Bethlehem PA
Stove/Furnace Make: RUSSO
Stove/Furnace Model: CW-2

Re: Trip to Hudson Breaker

PostBy: Duengeon master On: Thu Feb 04, 2010 1:31 pm

New Hope Engineer wrote:how did your little toyota handle the weight?
It handled it o.k. We had 1340 lbs. in the back. I am used to carrying that much but this time I had an extra 175+ lbs in the truck. That was good because Chris was a very good co-pilot and worth the extra weight. The only thing I was not counting on was that Short Bus won the last post wins and now I will gladly give him a bucket of coal for his victory. :lol: also I will with great pleasure give the winner some Balut. If you don't know what that is ask New Hope Engineer, Mark!
User avatar
Duengeon master
Member
 
Posts: 1898
Joined: Sun May 06, 2007 7:32 am
Location: Penndel, Pa.
Stove/Furnace Model: Harmon mark III ST8-VF8 stoker

Re: Trip to Hudson Breaker

PostBy: Richard S. On: Thu Feb 04, 2010 3:21 pm

They only heat a couple of small rooms. Office, bathroom and the break room. Proabably less than 500 sq ft.
User avatar
Richard S.
Mayor
 
Posts: 11050
Joined: Fri Oct 01, 2004 8:35 pm
Location: NEPA
Stove/Furnace Make: Van Wert
Stove/Furnace Model: VA1200

Re: Trip to Hudson Breaker

PostBy: New Hope Engineer On: Mon Feb 08, 2010 10:59 am

hey chris youll have to take me up to hudson to get a load! :o ;) :poke: :hammer:
User avatar
New Hope Engineer
Member
 
Posts: 447
Joined: Thu Aug 21, 2008 8:12 am
Location: Bethlehem PA
Stove/Furnace Make: RUSSO
Stove/Furnace Model: CW-2

Re: Trip to Hudson Breaker

PostBy: Duengeon master On: Mon Feb 08, 2010 6:35 pm

[quote="New Hope Engineer"]hey chris youll have to take me up to hudson to get a load! :o ;) :poke: :hammer:[/quoteI can take you Mark. I have nothing better to do.
User avatar
Duengeon master
Member
 
Posts: 1898
Joined: Sun May 06, 2007 7:32 am
Location: Penndel, Pa.
Stove/Furnace Model: Harmon mark III ST8-VF8 stoker

Re: Trip to Hudson Breaker

PostBy: New Hope Engineer On: Mon Feb 08, 2010 7:20 pm

Duengeon master wrote:
New Hope Engineer wrote:hey chris youll have to take me up to hudson to get a load! :o ;) :poke: :hammer:[/quoteI can take you Mark. I have nothing better to do.

it was an inside joke at chris.LOL thanx anyway.
User avatar
New Hope Engineer
Member
 
Posts: 447
Joined: Thu Aug 21, 2008 8:12 am
Location: Bethlehem PA
Stove/Furnace Make: RUSSO
Stove/Furnace Model: CW-2

Re: Trip to Hudson Breaker

PostBy: Duengeon master On: Mon Feb 08, 2010 7:45 pm

New Hope Engineer wrote:
Duengeon master wrote:
New Hope Engineer wrote:hey chris youll have to take me up to hudson to get a load! :o ;) :poke: :hammer:[/quoteI can take you Mark. I have nothing better to do.

it was an inside joke at chris.LOL thanx anyway.

I know, I am also part of it.

I don't care what everyone says, That Hudson coal burns good for me so far. :D I have never seen such lily white ash before.
User avatar
Duengeon master
Member
 
Posts: 1898
Joined: Sun May 06, 2007 7:32 am
Location: Penndel, Pa.
Stove/Furnace Model: Harmon mark III ST8-VF8 stoker

Re: Trip to Hudson Breaker

PostBy: New Hope Engineer On: Mon Feb 08, 2010 7:50 pm

if you wanted to see a little white ash, i could of just showed you mine! :shock: ;)
User avatar
New Hope Engineer
Member
 
Posts: 447
Joined: Thu Aug 21, 2008 8:12 am
Location: Bethlehem PA
Stove/Furnace Make: RUSSO
Stove/Furnace Model: CW-2

Re: Trip to Hudson Breaker

PostBy: cabinover On: Thu Oct 27, 2011 6:00 am

I know this thread is old but does anyone know the phone number for Hudson? I can't seem to find it.
cabinover
Member
 
Posts: 689
Joined: Wed Feb 04, 2009 8:13 am
Location: Fair Haven, VT
Stove/Furnace Make: Axeman-Anderson
Stove/Furnace Model: 130

Re: Trip to Hudson Breaker

PostBy: cabinover On: Thu Oct 27, 2011 6:06 am

Never mind, think I found it.
cabinover
Member
 
Posts: 689
Joined: Wed Feb 04, 2009 8:13 am
Location: Fair Haven, VT
Stove/Furnace Make: Axeman-Anderson
Stove/Furnace Model: 130

Re: Trip to Hudson Breaker

PostBy: anthony7812 On: Sat Nov 05, 2011 10:03 pm

Im guessing this is the yard in pittston. Anyone know the price per ton? Yeah im that guy who didnt fill the bin. Made a rather large bin, but couldnt quite commit to filling it until I had the first coal fire established. Wanted to keep the investment low as could until i could justify.
User avatar
anthony7812
Member
 
Posts: 698
Joined: Sat Mar 12, 2011 3:04 pm
Location: Colley,Pennsylvania
Stove/Furnace Make: Harman
Stove/Furnace Model: Mark III

Visit Lehigh Anthracite