masonry chimney

Re: masonry chimney

PostBy: oldmanstyle On: Sat Nov 03, 2012 9:53 pm

Thanks Berlin, I'll give them a call next week. Appreciate the reply !
oldmanstyle
 
Baseburners & Antiques: Glenwood #8 Baseburner
Coal Size/Type: Nut & Stove Anthracite

Re: masonry chimney

PostBy: Keepaeyeonit On: Sun Nov 04, 2012 6:44 am

Oldmanstyle if you find the liners let us know I may switch mine out,I was hoping I could get them from Raymond builders supply but I think you all ready tried them?give Dennis at Willougbhy concrete builders supply (440-942-4411) a call to see if he can get them (but I though I asked him about round liners some time back and he did not have them or can't get them I don't remember)Take care. Keepaeyeonit :)
Keepaeyeonit
 
Hand Fed Coal Stove: Hitzer 983 insert
Coal Size/Type: Mammoth nut
Other Heating: oil furnace,and a crappy heat pump

Re: masonry chimney

PostBy: oldmanstyle On: Sun Nov 04, 2012 9:07 am

I'll let you know Keepaeyeonit.
oldmanstyle
 
Baseburners & Antiques: Glenwood #8 Baseburner
Coal Size/Type: Nut & Stove Anthracite


Re: masonry chimney

PostBy: oldmanstyle On: Mon Nov 05, 2012 9:15 pm

For Berlin and Keepaeyeonit, no luck on the self aligning flue liners, Superior Clay in Columbus, Ohio says nobody's stocking them as there isn't any demand. As far as 8" regular round liners go, no one has a chimney block they will fit in, (10" outside diameter). Called Stony Run Supply as suggested but those block are for a "ChimTek" type chimney system. All that said, I'm going with 8"x8" flue liner and 16"x16" chimney block. Thanks again for the input, much appreciated.
oldmanstyle
 
Baseburners & Antiques: Glenwood #8 Baseburner
Coal Size/Type: Nut & Stove Anthracite

Re: masonry chimney

PostBy: Keepaeyeonit On: Tue Nov 06, 2012 9:00 am

Oldmanstyle,I called WCBS and he can get them but they are butt joint not lap joint.Keepaeyeonit
Keepaeyeonit
 
Hand Fed Coal Stove: Hitzer 983 insert
Coal Size/Type: Mammoth nut
Other Heating: oil furnace,and a crappy heat pump