Question about hardware

Re: Question about hardware

PostBy: Flyer5 On: Sat Oct 30, 2010 11:24 am

av8r wrote:
Flyer5 wrote:Another thing you can do is put the bolt in from the inside make it like a stud ,then use washers and nuts on the outside . That should be a simple fix .The problem with using stainless is if it gets overtightened the threads stretch causing the same issue of the bolt breaking on removal . Dave Dave

I'm not sure that will work without slotting the bolt hole to allow for the length of the bolt between the double steel. Also, how would you keep the bolt from turning? Have you tried this?

The extension box is 2" deep so all you will be going through is the weld nut and 10ga extension box so roughly 3/16 " . I have done it on our furnace ,I haven't tried it yet on anything else but don't see why it wouldn't work on the stoves . I will also try to get pics on Monday for this as well .Dave
Stoker Coal Boiler: Leisure Line WL110
Hot Air Coal Stoker Stove: Leisure Line Pioneer

Visit Leisure Line Stove