Barometric Damper placement?

Barometric Damper placement?

PostBy: 94Bison On: Mon Dec 24, 2012 8:57 pm

My stove has a rear vent. I have a 1 ft. pipe off the back hooked to a 90 then a 2 ft. section up hooked to the damper into another 2 foot section to a cut section about 1.5 foot to another 90 hooked to the powervent. My question....should I move the damper down to hook to the elbow then put the 2 ft. section above or is it ok the way it is? It seems I have read the recommendation is to hook the damper right into the 90 at the bottom. Will my current set up cause any problems? Thanks in advance for any insight!
94Bison
 
Stove/Furnace Make: Alaska
Stove/Furnace Model: Channing III

Re: Barometric Damper placement?

PostBy: McGiever On: Mon Dec 24, 2012 9:04 pm

The way you have it is best. :)
McGiever
 
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hot Air Coal Stoker Stove: HARMAN MAGNUM
Hand Fed Coal Stove: RADIANT HOME AIR BLAST
Baseburners & Antiques: OUR GLENWOOD 111 BASEBURNER "1908"
Coal Size/Type: PEA / ANTHRACITE, NUT-STOVE / ANTHRACITE
Other Heating: Ground Source Heat Pump
Stove/Furnace Make: Hydro Heat /Mega Tek