Manometer questions

Re: Manometer questions

PostBy: SMITTY On: Wed Feb 06, 2013 7:42 pm

I just left mine hooked up. Been there for a few years now. I share a flue with the oil boiler, so I mainly use it at the beginning and end of the season to set the baro damper on the boiler correctly. In the winter I set it in favor of the stove staying around .04". When the stove is disconnected for the summer, I set it back to .02" for the boiler for DHW duty.
SMITTY
 
Stoker Coal Boiler: Patriot Coal - custom built by Jim Dorsey
Hand Fed Coal Stove: Harman Mark III (not currently in use)
Coal Size/Type: Rice / Blaschak anthracite
Other Heating: Oil fired Burnham boiler

Re: Manometer questions

PostBy: Lightning On: Wed Feb 06, 2013 8:03 pm

joeq wrote:
Lightning wrote:#2. If you decide to put the mano between the stove and MPD, you could always just open the MPD completely to check what the chimney is pulling AND then when you close the MPD you will get an accurate reading of the negative pressure in the stove.

Now that makes sense to me Mr. Flash. I know this info is available around here somewhere, I just couldn't find it. I apologize for being redundant. Is there a metal barb available that I could thread into my stove pipe, and cap it off when the manometer tube is disconnected? Don't think I want the meter exposed 24-7 in my main foyer. I'll watch it for a week or 2, then put it away, and hook it up when I need to know the draft. Or am I looking at this the wrong way?



I leave mine hooked up all the time.. Once you get it hooked up and see how handy the new information is, you will probably want to leave it hooked up permanently.. Its especially useful in the spring on warm days, you can watch the draft pressure fall as it gets warmer outside.
Lightning
 
Hand Fed Coal Furnace: Clayton 1537G
Coal Size/Type: Nut/Stove Size Mix

Re: Manometer questions

PostBy: joeq On: Wed Feb 06, 2013 8:24 pm

Well guys, my stove is only supplemental heat. In a few more weeks, when the temps go above 40* highs, It won't see action till next Nov. As far as leaving the manometer hooked up all the time, the face is so big, there's no where to hide it. Being plastic, if I mount it directly behind the stove, I'm afraid it will melt. In an unfinished cellar installation, mounted away and on a wall, it wouldn't bother me, but not in my living area.
joeq
 
Hand Fed Coal Stove: Surdiac Gotha 513
Stove/Furnace Make: Oil fired
Stove/Furnace Model: Thermopride

Visit Hitzer Stoves

Re: Manometer questions

PostBy: Lightning On: Wed Feb 06, 2013 8:36 pm

joeq wrote:Well guys, my stove is only supplemental heat. In a few more weeks, when the temps go above 40* highs, It won't see action till next Nov. As far as leaving the manometer hooked up all the time, the face is so big, there's no where to hide it. Being plastic, if I mount it directly behind the stove, I'm afraid it will melt. In an unfinished cellar installation, mounted away and on a wall, it wouldn't bother me, but not in my living area.


Oh right on, I was meaning while you were running the stove :D
Lightning
 
Hand Fed Coal Furnace: Clayton 1537G
Coal Size/Type: Nut/Stove Size Mix

Visit Hitzer Stoves