Broken Glass
- Qball
- Member
- Posts: 147
- Joined: Sun. Oct. 05, 2008 4:31 pm
- Location: Rhode Island
- Hot Air Coal Stoker Stove: Keystoker Koker
- Coal Size/Type: Rice
- Contact:
Well I did it today, broke the glass on the Keystoker Koker. Was attempting to drill out some of the broken clips and of course I cracked the glass in half during the process. Where can I get replacement, Keystoker or somewhere else? I'm pretty sure all the remaining screws will have to be drilled too. Guess I should have done this over the summer
- freetown fred
- Member
- Posts: 30300
- Joined: Thu. Dec. 31, 2009 12:33 pm
- Location: Freetown,NY 13803
- Hand Fed Coal Stove: HITZER 50-93
- Coal Size/Type: BLASCHAK Nut
Check local glass shops Qb--tell em what you need it for.
-
- Member
- Posts: 62
- Joined: Thu. Sep. 13, 2012 2:21 pm
- Location: NEPA wilkes Barre - scranton area
- Hot Air Coal Stoker Stove: keystoker koker 160
- Hand Fed Coal Stove: Chubby rear vent
Qball,
Can you tell me the price for the new clips and glass from keystoker. I am considering ordering a spare one
Can you tell me the price for the new clips and glass from keystoker. I am considering ordering a spare one
- 2001Sierra
- Member
- Posts: 2211
- Joined: Wed. May. 20, 2009 8:09 am
- Location: Wynantskill NY, 10 miles from Albany
- Hot Air Coal Stoker Stove: Keystoker 90 Chimney vent
- Coal Size/Type: Rice
- Other Heating: Buderus Oil Boiler 3115-34
ANTI-SEIZE is your friend on all screws in a coal stove. I did mine when it was new, replaced all screws with stainless and of course anti-seize.
- freetown fred
- Member
- Posts: 30300
- Joined: Thu. Dec. 31, 2009 12:33 pm
- Location: Freetown,NY 13803
- Hand Fed Coal Stove: HITZER 50-93
- Coal Size/Type: BLASCHAK Nut
NICE Qb
-
- Member
- Posts: 174
- Joined: Sun. Aug. 24, 2008 11:29 am
- Location: South Glens Falls ny
- Hot Air Coal Stoker Furnace: Alaska stoker 140 Coal
Welp I just made the busted glass club also. Son closed the door a bit hard and pieces fell out, Hoping to get a new piece tomorrow. we"ll see. can one get at a local shop?? I can get gasket material at the hardware store, so one wonders.
- 2001Sierra
- Member
- Posts: 2211
- Joined: Wed. May. 20, 2009 8:09 am
- Location: Wynantskill NY, 10 miles from Albany
- Hot Air Coal Stoker Stove: Keystoker 90 Chimney vent
- Coal Size/Type: Rice
- Other Heating: Buderus Oil Boiler 3115-34
Gasket material is a common commodity. Good hardware stores and of course stove shops. Some has adhesive tape already on it. If not I had good luck with Imperial Gasket Cement that I got from my local True Value. My Keystoker 90 uses 1/2 inch flat for the glass seal. Just be careful not to stretch it when installing it so it will not try to shrink back Been there done that.