Where to Buy Bushing/Bearing, and Shafts?
- Richard S.
- Mayor
- Posts: 15123
- Joined: Fri. Oct. 01, 2004 8:35 pm
- Location: NEPA
- Stoker Coal Boiler: Van Wert VA1200
- Coal Size/Type: Buckwheat/Anthracite
I already have the slicone on them, really only need it to keep the grease from squiring out.
- Richard S.
- Mayor
- Posts: 15123
- Joined: Fri. Oct. 01, 2004 8:35 pm
- Location: NEPA
- Stoker Coal Boiler: Van Wert VA1200
- Coal Size/Type: Buckwheat/Anthracite
I didn't say which way they were off, they are about 1/64 too small. I think the original bushings might of been oversized a little becsue they hard to get pounded out. Part of the trouble here is I don't have a good set of calipers. I have calipers but I need to measure them with a ruler after taking the measurement.Rob R. wrote:My other idea was to score the bushing with a chisel, and then pound it in.
In any event they should work fine and if worse comes to worse I'll just have my Brother weld them in.