EFM oil pan screw needed

EFM oil pan screw needed

PostBy: ben On: Wed Feb 05, 2014 5:06 pm

The other day when I was cleaning my unit I dicided to change out my oil from the pan that holds a small amount visible oil. I think its thick gear oil in this pan.
While doing this I lost 1 of the screws. It looks like a machine type screw. The pan is supported by two screws. Somehow it got sucked up im my shop vac or something. Anyways it's lost. I need 1 any advise ?
I'm a funeral director not a plumber,--- but I do a good job of cleaning and maintaining my unit.

Thanks
ben
 
Stove/Furnace Make: EFM
Stove/Furnace Model: 350

Re: EFM oil pan screw needed

PostBy: franco b On: Wed Feb 05, 2014 5:10 pm

Just take the remaining screw to the hardware store to match up.
franco b
 
Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
Baseburners & Antiques: Glenwood Modern Oak 114
Coal Size/Type: nut and pea

Re: EFM oil pan screw needed

PostBy: scrapper_23jr On: Wed Feb 05, 2014 6:22 pm

A FIVE SIXTEENTH BY THREE QUARTER COURSE THREAD BOLT WILL DO THE JOB NOTHING SPECIAL ABOUT THE THREAD scrapper
scrapper_23jr
 

Re: EFM oil pan screw needed

PostBy: ben On: Wed Feb 05, 2014 7:35 pm

thanks a lot
ben
 
Stove/Furnace Make: EFM
Stove/Furnace Model: 350