Help Need Parts for an EFM 350 Stoker

apenkauski · Post by **apenkauski** » Sun. Feb. 23, 2014 10:40 pm

Hi I'm new to the forum. Looking for parts for an efm 350 that I've been having some trouble with. I need the two plates that the blower bolts to and the one the auger pipe runs through. I was wondering about the studs that attach the plates to the base box as well, are they pressed in or welded in? A few of them have sheared off and I would like to replace them. Also does anyone know the inside diameter of the auger tube, I need to run to lowe's for a piece of pipe as I only have the pipe that attaches to the pot. I am located in Minersville, PA. Thanks in advance.

windyhill4.2 · Post by **windyhill4.2** » Sun. Feb. 23, 2014 10:46 pm

Welcome to the coal forum, look under the furnaces/boilers/etc for sale items,member Glenn Harris, Scrapper are 2 that might have what you need or can direct you,good luck. & they are fairly close to you.

SWPaDon · Post by **SWPaDon** » Sun. Feb. 23, 2014 11:11 pm

If that doesn't work: http://efmheating.com/how-to-contact-efm-sales-company

Post by **Rob R.** » Mon. Feb. 24, 2014 4:58 am

Auger pipe is 2" schedule 40.

ryan20strohl · Post by **ryan20strohl** » Mon. Feb. 24, 2014 6:03 pm

Get some 1/8 flat sheets of metal drill your own holes and and the same for the worm tube also uses 3/8 bolts to hold then to the base your not going to remove them unless a major problem has occurred

Scottscoaled · Post by **Scottscoaled** » Mon. Feb. 24, 2014 6:53 pm

Those are 1" x 5/16" weld studs. You can get them online or from Fastenall. They are $.75 each. They weld in easily enough. The sides are only 1/8" plate. Use the old ones for template if you have them.