needing parts for a kenmore coal stove. 119100120

needing parts for a kenmore coal stove. 119100120

PostBy: Brad On: Mon Mar 10, 2014 9:03 pm

Iam trying to figure out what type of piping does it take from top of stove up. The opening is oval shaped.....so far i havent found anything that works....its an antique kenmore coal stove 119100120
Brad
 

Re: needing parts for a kenmore coal stove. 119100120

PostBy: Dennis On: Mon Mar 10, 2014 9:22 pm

Welcome Brad,are you looking for a oval to round cast iron stove pipe.
http://chubbystove.com/gallery2.htm
Call to see if the dimentions are correct
Dennis
 
Hand Fed Coal Boiler: AHS/WOC55-multi-fuel/wood,oil,coal
Coal Size/Type: Anthracite/stove size

Re: needing parts for a kenmore coal stove. 119100120

PostBy: dhansen On: Mon Mar 10, 2014 10:06 pm

Brad, if you can show us a couple of photos of the top of your stove we'd have a better chance of finding a solution.
dhansen
 
Stove/Furnace Make: Glenwood No.6 and No.116

Visit Hitzer Stoves

Re: needing parts for a kenmore coal stove. 119100120

PostBy: rockwood On: Mon Mar 10, 2014 11:21 pm

If you're not sure of the size pipe needed to match the oval outlet of the stove, this post gives the circumferences of common stove pipe sizes so you can measure the oval to determine the size you need.

New Stove Question

I never use any special oval to round adapter, I just squeeze the stove pipe to an oval shape and slide it on the oval outlet of the stove. I always use "blue steel stove pipe" for this application because it's a thinner gauge and easier to work with but most hardware stores don't carry it anymore so you might have trouble finding it locally.
If you're planning to use the heavier gauge black stove pipe commonly sold at hardware stores, it will be harder to manipulate to an oval shape to fit the stove, so an adapter would be easier in that case.
rockwood
 
Hot Air Coal Stoker Furnace: Stokermatic coal furnace
Hand Fed Coal Stove: Rockwood Stoveworks Circulator
Baseburners & Antiques: Malleable/Monarch Range
Coal Size/Type: Soft coal: Lump and stoker (slack coal)

Re: needing parts for a kenmore coal stove. 119100120

PostBy: Sunny Boy On: Tue Mar 11, 2014 5:39 am

Wrap a piece of string around the pipe collar and make a mark where the end of the string meets the rest of the string. Then measure the length of string to the mark.

See which of the numbers that Rockwood posted is closest to that length.

If it's an oddball size, Bryant Stove in Maine can make a tapered pipe section for you.

Paul
Sunny Boy
 
Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
Coal Size/Type: Nuts !
Other Heating: Oil &electric plenum furnace

Visit Hitzer Stoves

cron