F350 Randomly Won't Start

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Wed. Aug. 13, 2014 1:51 pm

... and for the hell of it, I would replace the Cam Positioning Sensor. How old is yours? Every vehicle has it's little weaknesses.


 
User avatar
northernmainecoal
Member
Posts: 555
Joined: Wed. Jan. 22, 2014 8:33 am
Location: Aroostook County, Maine
Stoker Coal Boiler: EFM 520
Hand Fed Coal Stove: Hitzer 30-95
Baseburners & Antiques: Herald Baseheater #6
Coal Size/Type: Rice/Nut/Stove

Post by northernmainecoal » Wed. Aug. 13, 2014 2:11 pm

As far as I know it has the orignal one in it. Fairly easy to swap out?

 
User avatar
northernmainecoal
Member
Posts: 555
Joined: Wed. Jan. 22, 2014 8:33 am
Location: Aroostook County, Maine
Stoker Coal Boiler: EFM 520
Hand Fed Coal Stove: Hitzer 30-95
Baseburners & Antiques: Herald Baseheater #6
Coal Size/Type: Rice/Nut/Stove

Post by northernmainecoal » Wed. Aug. 13, 2014 2:59 pm

Where did you get your bullydog air intake from?

 
User avatar
EarthWindandFire
Member
Posts: 1594
Joined: Sat. Dec. 18, 2010 12:02 pm
Location: Connecticut
Hot Air Coal Stoker Furnace: Leisure Line Lil' Heater.
Other Heating: Oil Furnace and Kerosene Heaters.

Post by EarthWindandFire » Wed. Aug. 13, 2014 3:40 pm

Drive to your nearest big city and park the truck with the windows rolled down. Tie some balloons on the antenna and cross your fingers. 8-)

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Wed. Aug. 13, 2014 4:47 pm

As far as I know it has the orignal one in it. Fairly easy to swap out?
Piece of cake 10mm wrench, two terminals and out with it. The internet is full of why the original ones were dodgy and I think they were a subject of an official Ford recall. You DEFINITELY need to replace it by now. In this case it's worth it to buy from Ford and they should give it to you. I keep a spare and a 10mm wrench and flashlight for long trips. If this old fart can do it anyone can. I am sure there is a youtube video of it.

Bully dog is all over the internet too many places stock them. Youtube will have videos too but I will photo mine if you wish. Let us know how you get on, you have my undivided attention. Something socket in Maine in winter is not a place to have a dodgy truck. How can you possibly drive around beating the bushes for base heaters for us if your truck does not work. :)

 
User avatar
freetown fred
Member
Posts: 30302
Joined: Thu. Dec. 31, 2009 12:33 pm
Location: Freetown,NY 13803
Hand Fed Coal Stove: HITZER 50-93
Coal Size/Type: BLASCHAK Nut

Post by freetown fred » Wed. Aug. 13, 2014 5:22 pm

Yeah really! What's that all about nmc??? Of course ya do own a Ford :clap: toothy

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Wed. Aug. 13, 2014 5:26 pm

Yeah really! What's that all about nmc??? Of course ya do own a Ford :clap: toothy
Who asked you? Go back to humping those bull calves. AHHAHAAHAHAHAA, I slay myself.


 
User avatar
northernmainecoal
Member
Posts: 555
Joined: Wed. Jan. 22, 2014 8:33 am
Location: Aroostook County, Maine
Stoker Coal Boiler: EFM 520
Hand Fed Coal Stove: Hitzer 30-95
Baseburners & Antiques: Herald Baseheater #6
Coal Size/Type: Rice/Nut/Stove

Post by northernmainecoal » Wed. Aug. 13, 2014 6:37 pm

FF I know what you're doing out there in the sheep pasture with your trench coat on and the poor sheeps back legs dropped down into your rubber boots...ya ain't foolin' anyone :lol:

I stopped in the garage after work they are going to replace the ICP valve in the morning...it SHOULD fix it :shock: we shall see
I need to be out looking for base heaters that's for sure
So far I just keep finding used EFMs now I have a new one :x

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Wed. Aug. 13, 2014 6:45 pm

I stopped in the garage after work they are going to replace the ICP valve in the morning...it SHOULD fix it :shock: we shall see
I need to be out looking for base heaters that's for sure
So far I just keep finding used EFMs now I have a new one :x
Let us know as this board exists to help each other. I still strongly advise changing the CPS. Never mind what FF/EWF says, the 7.3 is one of the very best.
Last edited by coalnewbie on Thu. Aug. 14, 2014 2:24 am, edited 1 time in total.

 
User avatar
northernmainecoal
Member
Posts: 555
Joined: Wed. Jan. 22, 2014 8:33 am
Location: Aroostook County, Maine
Stoker Coal Boiler: EFM 520
Hand Fed Coal Stove: Hitzer 30-95
Baseburners & Antiques: Herald Baseheater #6
Coal Size/Type: Rice/Nut/Stove

Post by northernmainecoal » Wed. Aug. 13, 2014 7:01 pm

I will let you know. I read the board daily it is the best!
I will change the CPS, thank you!

 
User avatar
SMITTY
Member
Posts: 12526
Joined: Sun. Dec. 11, 2005 12:43 pm
Location: West-Central Mass
Stoker Coal Boiler: EFM 520 Highboy
Coal Size/Type: Rice / Blaschak anthracite
Other Heating: Oil fired Burnham boiler

Post by SMITTY » Thu. Aug. 14, 2014 9:24 am

Hope you have better luck than I'm having with this POS '96 Tahoe ... :roll:

Electronics & emissions .... :mad3:

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Thu. Aug. 14, 2014 10:23 am

Smitty, as John Wayne said.

“Tomorrow hopes we have learned something from yesterday.”

So are we still lining up at the GM counter? A Jimmy and now Tahoe, are we seeing a trend here.

 
User avatar
northernmainecoal
Member
Posts: 555
Joined: Wed. Jan. 22, 2014 8:33 am
Location: Aroostook County, Maine
Stoker Coal Boiler: EFM 520
Hand Fed Coal Stove: Hitzer 30-95
Baseburners & Antiques: Herald Baseheater #6
Coal Size/Type: Rice/Nut/Stove

Post by northernmainecoal » Thu. Aug. 14, 2014 1:57 pm

Well they put in the new ICP, charged the batteries and it started right up. Let it run for a bit shut it off and guess what? It didn't fking start again :mad: :bang: :bang: :bang:

 
User avatar
whistlenut
Member
Posts: 3548
Joined: Sat. Mar. 17, 2007 6:29 pm
Location: Central NH, Concord area
Stoker Coal Boiler: AA130's,260's, AHS130&260's,EFM900,GJ & V-Wert
Hand Fed Coal Boiler: Franks,Itasca 415,Jensen, NYer 130,Van Wert
Hot Air Coal Stoker Furnace: Alaska, EFM, Keystoker, Yellow Flame
Hot Air Coal Stoker Stove: Alaska, Keystoker-2,Leisure Line
Hand Fed Coal Stove: Alaska, Gibraltar, Keystone,Vc Vigilant 2
Hand Fed Coal Furnace: Ford, Jensen, NYer, Van Wert,
Baseburners & Antiques: Glenwoods
Coal Size/Type: Barley, Buck, Rice ,Nut, Stove
Other Heating: Oil HWBB

Post by whistlenut » Thu. Aug. 14, 2014 2:31 pm

If you are not a AAA member it pays to belong. Make sure towing is on you list of benefits. Next, take a handful of excellent maps and plan a route to coastal Maine that has a veeeerrrrrrryyyyy deep ocean shelf. Secure flotation devices that will self destruct 60 minutes from shore.....job done. Please remove all the oils and pollutants, as this will be a Malaysia Airlines reservation. Kiss it goodbye....and that Barney Frank feeling will just be a distant memory in the morning. They all are a PITA, just ask the Mercer boys with the Sprinters. Excellence is a goal, not a reality, always.

If it has wheels, floats, flies, or has a ........................, you can't afford it, nor should you have it!!

Electrical gremlins effect all of us who live in the 'Steel Body Cancer Center of the Universe'. saw an 07 GMC 3500 last night with a foot of frame rotted out behind the drivers door. SHOCKING.
Brake lines were replaced the year before...........it must be a contest to see who can develop the worst, most corrosive , chemicals to add to the environment. The dumb bast**ds can't seem to remember that our drinking water is in the runoff from that crap. Tupperware trucks and cars...thats the ticket. Freddie is back in the sheep pasture? He got those special boots when he was in VT as I recall. I think they are call 'Burlington Booty Boots'. Lamolynn is her name......

 
User avatar
northernmainecoal
Member
Posts: 555
Joined: Wed. Jan. 22, 2014 8:33 am
Location: Aroostook County, Maine
Stoker Coal Boiler: EFM 520
Hand Fed Coal Stove: Hitzer 30-95
Baseburners & Antiques: Herald Baseheater #6
Coal Size/Type: Rice/Nut/Stove

Post by northernmainecoal » Thu. Aug. 14, 2014 2:48 pm

and now we are replacing the HPOP


Post Reply

Return to “Cars, Trucks, Motorcycles & Aviation”