Where to Buy or How to Make Coal Door & Chute

Post Reply
 
revtim
Member
Posts: 50
Joined: Wed. Aug. 13, 2014 5:57 pm
Location: Dundee, Michigan
Hot Air Coal Stoker Furnace: reading
Hot Air Coal Stoker Stove: keystoker
Coal Size/Type: rice
Other Heating: FALP

Post by revtim » Sun. Aug. 17, 2014 3:25 pm

I've decided to go with bulk coal and have room in the basement for the bin. Now I just need to figure out how to get a coal chute and door. The bin will be directly below the door in the wall so all I need to do is install the door/chute but can't seem to find anyone that manufactures them... nor can I find a used one. In order of preference, I would like one that goes with my 1890's farm house style-wise either a real one or a new one with the retro design. Alternately, a new one would be great too. Failing that, I am planning to install a removable sash window which will serve as the coal chute door. That seems to be the most reasonable alternative and may in fact be the best solution as well.

Any thoughts??

 
User avatar
Wiz
Member
Posts: 926
Joined: Sun. Nov. 27, 2011 8:45 pm
Location: Tannersville Pa
Stoker Coal Boiler: Keystoker Ka 6
Coal Size/Type: Casey Junk Coal :(

Post by Wiz » Sun. Aug. 17, 2014 3:37 pm


 
revtim
Member
Posts: 50
Joined: Wed. Aug. 13, 2014 5:57 pm
Location: Dundee, Michigan
Hot Air Coal Stoker Furnace: reading
Hot Air Coal Stoker Stove: keystoker
Coal Size/Type: rice
Other Heating: FALP

Post by revtim » Sun. Aug. 17, 2014 5:01 pm

Randy, ebay is the first place I went and I saw that but I didn't think it was a external door. Perhaps I just couldn't figure out how it works.

It was not at all like the other coal chute doors I had seen online. I'll write the seller and see if I can get some more pictures to help me understand how it works and if it can be installed on my outside wall. It is kinda pretty though with all that Victorian frill.

 
User avatar
Wiz
Member
Posts: 926
Joined: Sun. Nov. 27, 2011 8:45 pm
Location: Tannersville Pa
Stoker Coal Boiler: Keystoker Ka 6
Coal Size/Type: Casey Junk Coal :(

Post by Wiz » Sun. Aug. 17, 2014 5:20 pm

What about a chimney clean out door something like this http://www.nfco.com/municipal/products/misc-produ ... mes-doors/


 
revtim
Member
Posts: 50
Joined: Wed. Aug. 13, 2014 5:57 pm
Location: Dundee, Michigan
Hot Air Coal Stoker Furnace: reading
Hot Air Coal Stoker Stove: keystoker
Coal Size/Type: rice
Other Heating: FALP

Post by revtim » Fri. Aug. 22, 2014 10:32 am

Thanks for that idea. It might work. However, I am now thinking about just installing a removable sash window. that way, it's insulated... lockable and brings light into the area.

Given typical deliveries of bulk these days, anyone have a good idea as to the dimensions of the opening that will most reasonably accommodate the coal as it's being delivered? I don't see a problem building a chute to fit the opening but want to make sure it's big enough to take the amount of coal coming off the truck. Any input would be appreciated.

 
User avatar
McGiever
Member
Posts: 10130
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Fri. Aug. 22, 2014 12:05 pm

Any decent coal delivery man brings his own chute with him, so no need to have your own.

COAL BIN Pics

 
User avatar
Richard S.
Mayor
Posts: 15184
Joined: Fri. Oct. 01, 2004 8:35 pm
Location: NEPA
Stoker Coal Boiler: Van Wert VA1200
Coal Size/Type: Buckwheat/Anthracite

Post by Richard S. » Fri. Aug. 22, 2014 12:08 pm

Long as you have a window, the bigger the better however the bottom ledge of window should be as high as possible assuming high lift delivery.

Post Reply

Return to “Coal Bins, Chimneys, CO Detectors & Thermostats”