Need 8" Wall Termination for Harman DVC500

Elfmaze · Post by **Elfmaze** » Fri. Sep. 26, 2014 8:45 pm

where are you at? kc stoves in albertsville has one

DVC 500 Burner · Post by **DVC 500 Burner** » Thu. Nov. 13, 2014 9:37 am

Hey guys,

I'm resurrecting this thread because I have the same problem as the OP. However, I'm lucky enough to know a guy that bent me up a piece of stainless to replace the outer piece of my wall termination that rusted. I thought that was all I needed but then I looked at the picture in the manual and it seems like there might be another piece of sheet metal I need?

Can anyone post a piece of an intact wall termination for a DVC 500? Could be either the 12" (1-10-08310), 16" (1-10-08311), or 20" (1-10-08312). It doesn't matter.

Thanks!

Elfmaze · Post by **Elfmaze** » Thu. Nov. 13, 2014 10:23 am

I almost feel like pulling out the TIG welder and making some of these things. Seems Harman has stopped making them. Fortunately I didn't buy the dvc500 although I really liked the design. Less the computer stuff