A Conveyor Belt??

Post Reply
 
Kungur
Member
Posts: 722
Joined: Thu. Sep. 25, 2008 7:09 am
Location: Chardon,Ohio

Post by Kungur » Sun. Sep. 21, 2014 8:10 am

This week after moving all my coal I was wondering about making a small conveyor belt set up. Something that would move the coal about 10-12 feet through a hole in the house then dropping it into the bin. The auger idea is not workable because the power head would need to be inside the house and there is no clearance.
So anyone made one or have any ideas? Found belting on McMaster Carr.
Thanks!

 
User avatar
McGiever
Member
Posts: 10130
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Sun. Sep. 21, 2014 8:21 am

Here's one idea:
I have seen augers that have no bulky large electric power-heads, they use a much smaller hydraulic motor on the auger shaft and then 2 lengths of hose run to a remote power pack. :idea:


 
Lu47Dan
Member
Posts: 286
Joined: Wed. Jan. 29, 2014 1:42 pm
Location: N/W Pa. Meadville, Pa.
Hand Fed Coal Stove: Sears circulator air tight stove.
Other Heating: Crown 115,000 BTU oil fired boiler(house) Weil Mclain 150,000BTU oil fired boiler(Shop)

Post by Lu47Dan » Sun. Sep. 21, 2014 11:34 am

Kungur wrote:This week after moving all my coal I was wondering about making a small conveyor belt set up. Something that would move the coal about 10-12 feet through a hole in the house then dropping it into the bin. The auger idea is not workable because the power head would need to be inside the house and there is no clearance.
So anyone made one or have any ideas? Found belting on McMaster Carr.
Thanks!
Have you thought of moving the motor to the bottom of the auger instead of the head?
If you have the ability to build a belt conveyor than you should be able to swap the motor around.
If the auger has a good heavy motor on it than it should be reversible. Most farm elevators and conveyors are bottom driven for convenience of maintenance , all the augers I have seen have the motor on the head end to protect it from being damaged while unloading. Since you are most likely shoveling coal into the hopper you would not have to worry about the gravity box or a skid steer bucket running into the motor.
Another thing you could do is to move the motor half way down the tube and drive the head end off a shaft. Would probably be the easiest and quickest way to convert the auger.
Building the conveyor would run into quite a bit of money compared to relocating the drive motor and hopper on an auger.
Dan.

 
User avatar
carlherrnstein
Member
Posts: 1536
Joined: Tue. Feb. 07, 2012 8:49 am
Location: Clarksburg, ohio
Hot Air Coal Stoker Stove: combustioneer model 77B
Coal Size/Type: pea stoker/Ohio bituminous

Post by carlherrnstein » Wed. Sep. 24, 2014 5:48 pm

Conveyor belts are a pain to deal with. If the rollers are just a little out of parallel then it will run off the side.

Post Reply

Return to “Coal Bins, Chimneys, CO Detectors & Thermostats”