AK 110 Instal
-
- New Member
- Posts: 13
- Joined: Sun. Jun. 29, 2014 10:28 am
- Location: Wyoming, NY
- Hot Air Coal Stoker Furnace: Leisure Line AK 110
- Other Heating: Forced air fuel oil
I am in the process of installing my ak110. It is going fairly well although the instruction sheet could be a little better. Phone calls to leisure line have been imediatly answered and questions anwered also. What I am looking for is a back flow damper to put in the plenum isolate the new from the old. Any sugestions?
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
Cut a piece of tin, cement-board or plywood, your choice, and slide it in where the air filter would go.
And be sure to disable/disconnect power to the one that's blocked...bad things will happen if the blocked one were to start.
And be sure to disable/disconnect power to the one that's blocked...bad things will happen if the blocked one were to start.
-
- New Member
- Posts: 13
- Joined: Sun. Jun. 29, 2014 10:28 am
- Location: Wyoming, NY
- Hot Air Coal Stoker Furnace: Leisure Line AK 110
- Other Heating: Forced air fuel oil
This is what I came up with made by Dayton available threw Grangers. Got one for my AK110 and my oil furnace. These are pics from my plenum for the AK