Anyone know where I can pick up an approx 12 x 20" plenum and then run two 6 or 8" round lines off of that? Has anyone come up with some sort of transition part that would have two round cut outs? My plan is to run the round pipe into existing duct work at different locations of basement. Somebody must have wanted to do this style
Setup before.
Thanks
Duct Question
-
- Member
- Posts: 58
- Joined: Thu. Sep. 11, 2014 7:06 pm
- Location: Brunswick, NY
- Hot Air Coal Stoker Furnace: Keystoker koker lite
- Other Heating: FHA oil furnace
-
- Member
- Posts: 601
- Joined: Wed. Apr. 09, 2008 7:05 am
- Location: Geauga County, NE Ohio
- Hot Air Coal Stoker Furnace: Keystoker Koker
- Coal Size/Type: rice
You may find this site helpful: http://www.graymetal.com/products
I expect you'll purchase the rectangular duct, cut two 6 or 8 inch holes in it, install a couple of starter collars and you're on your way.
I expect you'll purchase the rectangular duct, cut two 6 or 8 inch holes in it, install a couple of starter collars and you're on your way.
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
How many BTU can those 2 round ducts move for you?
And is that only partial output from that Koker Lite?
And is that only partial output from that Koker Lite?