520 to Maney Auger Teeth
I put in an older 520 this one doesn't have the thumb screw to adjust the speed of auger it has a bolt that slides back and forth where it comes out of transmission. I have moved it and the slowest I can get it is 4-5 teeth is there any other adjustment?
-
- Member
- Posts: 145
- Joined: Tue. Jul. 03, 2012 10:00 pm
- Stoker Coal Boiler: efm coal boiler
- Coal Size/Type: rice
- Other Heating: Bryant evolution heat pump
I had the same issue were the connecting rod bolts to there is a pan head bolt grid one down and put it towards the inside u will get 3 teeth thats the lowest I got with out the thumb screw
- Rob R.
- Site Moderator
- Posts: 18004
- Joined: Fri. Dec. 28, 2007 4:26 pm
- Location: Chazy, NY
- Stoker Coal Boiler: EFM 520
- Hand Fed Coal Stove: Chubby Jr
If you move the bolt to the edge of the slot, it should run 4 teeth...which is fine. In most applications there is no real benefit to running less than 4 teeth.