Ten teeth

Ten teeth

PostBy: Scottscoaled On: Thu Feb 21, 2008 11:25 pm

Stokerman, how do you get the ten teeth range( not that I need it )? Mine only goes to 8 teeth. Is there a different lever on the clutch that changes out? Just wondering :) Scott
Scottscoaled
 
Stoker Coal Boiler: EFM 520x4, 350, 700. Van Wert 400 x 2, 800, 1200.
Coal Size/Type: Lots of buck

Re: Ten teeth

PostBy: stoker-man On: Fri Feb 22, 2008 8:44 am

Your feed rate should go to 10 or 11 teeth. I just checked our stoker to confirm it.
stoker-man
 
Hand Fed Coal Boiler: 1981 efm wcb-24 in use 365 days a year
Coal Size/Type: Anthracite/Chestnut
Other Heating: Hearthstone wood stove

Re: Ten teeth

PostBy: Scottscoaled On: Tue Feb 26, 2008 11:12 pm

Nope, mine only goes to 7 teeth. What is the center to center measurement of the arm that turns around off the gear reducer? could it be that mine is for a S15 stoker? It is a rebuild. Not that it's necessary. Scott
Scottscoaled
 
Stoker Coal Boiler: EFM 520x4, 350, 700. Van Wert 400 x 2, 800, 1200.
Coal Size/Type: Lots of buck

Re: Ten teeth

PostBy: stoker-man On: Wed Feb 27, 2008 6:57 am

Pictorial: S-20 Stoker assembly w/part numbers (DF520)

Go to that link and look at the pictures. Do a close-up on the crank. It should have S 20 cast into it.
stoker-man
 
Hand Fed Coal Boiler: 1981 efm wcb-24 in use 365 days a year
Coal Size/Type: Anthracite/Chestnut
Other Heating: Hearthstone wood stove

Re: Ten teeth

PostBy: Scottscoaled On: Wed Feb 27, 2008 11:40 pm

Part # 9433719 Is the one. Just checked and your right, the part is stamped with S15. Appreciate your help. My stove is set up fine. That part is not important ,I just wanted to know. Scott
Scottscoaled
 
Stoker Coal Boiler: EFM 520x4, 350, 700. Van Wert 400 x 2, 800, 1200.
Coal Size/Type: Lots of buck