Coal Insert Install
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
I'm picking up a coal insert on Friday. My plan is to install it the following way.
Of course it will be going in my fireplace. My idea is to run a piece of 6" flex liner up into the Chimney to get it above the smoke shelf. I already have a plate made of sheet metal that covered the damper, so I'm going to cut a whole big enough for the liner to fit through, the seal it up with fiberglass insulation. Once it's hooked up and the air gaps sealed ill slide the insert in to the desired depth. Anything else I should do?
Of course it will be going in my fireplace. My idea is to run a piece of 6" flex liner up into the Chimney to get it above the smoke shelf. I already have a plate made of sheet metal that covered the damper, so I'm going to cut a whole big enough for the liner to fit through, the seal it up with fiberglass insulation. Once it's hooked up and the air gaps sealed ill slide the insert in to the desired depth. Anything else I should do?
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
Sorry about the triple post, I have no idea how that even happened.
- coaledsweat
- Site Moderator
- Posts: 13767
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
Magic? I think not!xandrew245x wrote:Sorry about the triple post, I have no idea how that even happened.
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
Totally magic
- coaledsweat
- Site Moderator
- Posts: 13767
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
Actually, you made four.
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
Geez, I was posting from my phone, it must have went nuts.
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
Partially blame it on my Internet too
-
- Member
- Posts: 6515
- Joined: Sun. Feb. 10, 2008 3:48 pm
- Location: Cape Cod, MA
- Stoker Coal Boiler: want AA130
- Hand Fed Coal Stove: DS Machine BS#4, Harman MKII, Hitzer 503,...
- Coal Size/Type: Pea/Nut/Stove
If the chimney has a good draft then you are all set...
If it is too big and cold to heat up properly...
You may need to run the liner higher to the top...
If it is too big and cold to heat up properly...
You may need to run the liner higher to the top...
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
It appears to be a 12x12 flue, I never had draft problems with my pellet stove, but that's different. I'll try it out this way and if it doesn't have good enough draft then i'll go clear to the top.
- coaledsweat
- Site Moderator
- Posts: 13767
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
How tall is this chimney above the appliance?
-
- Member
- Posts: 504
- Joined: Sat. Nov. 24, 2012 2:26 pm
- Location: Gardners, PA
- Hot Air Coal Stoker Stove: keystoker 90
- Hand Fed Coal Stove: aarrow stratford 75
- Coal Size/Type: anthracite nut/rice
- Other Heating: Oil boiler, fireplace
At least 15'
- coaledsweat
- Site Moderator
- Posts: 13767
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
Should be OK.