I-Box Setup

I-Box Setup

PostBy: wilder11354 On: Sun Jan 29, 2017 4:37 pm

did a rough setup of Incra I-box finger joint cutter. Set it up as a right hand tilt blade on tablesaw. If I am correct, blade tilts to right from operating position its right tilt. Anybody out here know if it right or wrong, please let me know.
Ibox1.jpg
(97.09 KiB) Viewed 9 times
View: New PagePopup • Select:BBCode
[nepathumb]78690[/nepathumb]
Ibox2.jpg
(80.42 KiB) Viewed 10 times
View: New PagePopup • Select:BBCode
[nepathumb]78691[/nepathumb]
Ibox3.jpg
(99.39 KiB) Viewed 5 times
View: New PagePopup • Select:BBCode
[nepathumb]78692[/nepathumb]
Ibox4.jpg
(104.44 KiB) Viewed 5 times
View: New PagePopup • Select:BBCode
[nepathumb]78693[/nepathumb]
wilder11354
 
Hand Fed Coal Boiler: Harman SF260 Boiler
Coal Size/Type: nut or pea, anthracite
Other Heating: crown oil boiler, backup.if needed


Re: I-Box Setup

PostBy: cabinover On: Sun Jan 29, 2017 4:50 pm

Wish I could help you but I have never seen or heard of the product. Do have an Incra miter fence though, works much better than the stock POS.
cabinover
 
Stoker Coal Boiler: Hybrid Axeman Anderson 130
Baseburners & Antiques: Sparkle #12
Coal Size/Type: Pea, Buckwheat, Nut
Other Heating: LP Hot air. WA TX for coal use.

Re: I-Box Setup

PostBy: waldo lemieux On: Mon Jan 30, 2017 9:58 am

Wildman, I understand your question to be, if the blade tilts to the right as your standing behind the saw, is it a right tilt saw.? if thats the question, then the answer is yes. Most all contractor saws are right tilt. Some higher end cabinet saws are left tilt. I have one and it would be nice if I had a right as well, sometimes its nice to have a choice.
waldo lemieux
 
Stove/Furnace Make: efm
Stove/Furnace Model: s-20

Re: I-Box Setup

PostBy: wilder11354 On: Mon Jan 30, 2017 7:15 pm

waldo lemieux wrote:Wildman, I understand your question to be, if the blade tilts to the right as your standing behind the saw, is it a right tilt saw.? if thats the question, then the answer is yes. Most all contractor saws are right tilt. Some higher end cabinet saws are left tilt. I have one and it would be nice if I had a right as well, sometimes its nice to have a choice.
Thank You Waldo!! so good on incra box set up, just need scrap wood, and dado blade installed to practice using it.
wilder11354
 
Hand Fed Coal Boiler: Harman SF260 Boiler
Coal Size/Type: nut or pea, anthracite
Other Heating: crown oil boiler, backup.if needed