Draft Inducer and Mounting It

Re: Draft Inducer and Mounting It

PostBy: Rick 386 On: Mon. Mar. 27, 2017 2:41 pm

Rob R. wrote:Rick, does your 260 have a separate aquastat for a high limit control?


Rob,

I'm just using the standard L 8124c

I do know there is another tapping where I could put I think it is a L4006 ????? for a dump zone. Forget whether it would need the A or C model. Plus I would need to add another pump to make a 3rd zone for dumping only.

Rick
Rick 386
 
Stoker Coal Boiler: AA 260 heating both sides of twin farmhouse
Hot Air Coal Stoker Stove: LL Hyfire II w/ coaltrol in garage
Coal Size/Type: Pea in AA 260, Rice in LL Hyfire II
Other Heating: Gas fired infared at work


Re: Draft Inducer and Mounting It

PostBy: coaledsweat On: Mon. Mar. 27, 2017 3:17 pm

It should already have a L4006 as a overtemp control that kills power to the unit. If you run a timer, this is a must. It does not have one?
coaledsweat
 
Stoker Coal Boiler: Axeman Anderson 260M
Coal Size/Type: Pea

Re: Draft Inducer and Mounting It

PostBy: Rick 386 On: Mon. Mar. 27, 2017 5:32 pm

coaledsweat wrote:It should already have a L4006 as a overtemp control that kills power to the unit. If you run a timer, this is a must. It does not have one?


The original controls were 2 L 4006 aquastats. 1 in the front tapping to turn it on and make heat, and the other in the rear tapping to turn it off.

When I replumbed and rewired it, I tore all the old controls and wiring out. Too many wires hanging off the rafters to suit me. I added an L8124c aquastat to the front tapping. The 8124c controls 2 R845a relays. 1 for each zone circulator pump. Each side of the twin farmhouse has its own thermostat and is its own single zone.

There was an attempt to use a timer many, many years ago. However it was never hooked up properly so it was never used. There was no dump zone hooked into it either. That timer wiring was also removed by me.

Here is what it looked like when I was connecting everything:

20161013_212751.jpg
(116.65 KiB) Viewed 13 times
View: New PagePopup • Select:BBCode
[nepathumb]80273[/nepathumb]


Rick
Rick 386
 
Stoker Coal Boiler: AA 260 heating both sides of twin farmhouse
Hot Air Coal Stoker Stove: LL Hyfire II w/ coaltrol in garage
Coal Size/Type: Pea in AA 260, Rice in LL Hyfire II
Other Heating: Gas fired infared at work

Re: Draft Inducer and Mounting It

PostBy: coaledsweat On: Mon. Mar. 27, 2017 5:36 pm

I believe that PRV should be on the port at the top of the boiler near the water out bung. Never saw one on the side like that on anything. Not sure if it matters, maybe an expert will chime in on that.
coaledsweat
 
Stoker Coal Boiler: Axeman Anderson 260M
Coal Size/Type: Pea