Setting the Feed rate on Coal-Trol When Lighting Stove

Setting the Feed rate on Coal-Trol When Lighting Stove

PostBy: StanT On: Sun. Apr. 23, 2017 7:19 am

When my stove is shut down for cleaning and I start it back up the feed rate is always over 90. Is there a way to reset this or lower it as I get a full grate of fire when I light it.

Help Please.

Thanks, Stant
StanT
 
Stove/Furnace Make: Leisureline
Stove/Furnace Model: econo1


Re: Setting the Feed rate on Coal-Trol When Lighting Stove

PostBy: pvolcko On: Mon. Apr. 24, 2017 9:28 am

When you're cleaning it set the setpoint a bit below room temp, this will keep it from ramping up while it is out of service.

If you have a thermostat with V4 009 or higher version of the firmware there is also a feature to reset the FR logic. Go to the FR screen, press and hold the down button for 15 seconds. The FR will reset to a low value (maybe not 0 depending on where your setpoint is vs room temp).
pvolcko