Fixing a Magnum Stoker Feed Adjustent Problem

Fixing a Magnum Stoker Feed Adjustent Problem

PostBy: ginski On: Sat Oct 04, 2008 4:39 pm

While adjusting the feed on the magnum stoker, the wing nut would no longer stay tight against the adjuster & adjuster tube. The 5/16" threaded rod was no longer fully seated & tight into the pusher block.

To solve this problem (turn feed switch off) take the wing nut & bar adjuster off the threaded rod. Install (2) 5/16 x 18 nuts back to back on the threaded rod & tighten against each other so neither moves. Now just put a wrench on the outer nut & tighten the threaded rod back into the pusher block until tight. Don't overdue it or you may snap the threaded rod.

Perhaps others have had this problem & maybe this will help...even though the solution is pretty obvious.

regards to all,
tom
ginski
 
Stove/Furnace Make: harman
Stove/Furnace Model: magnum stoker

Visit Leisure Line