Ok, I have posted on here about the Coal-trol feedrate at 99 even when the room temp is 10 degrees above what the coal-trol is set for, this was mostly happening when I tried increasing the day or night temp by 2 degrees as it started getting colder outside. I have been patient with that, although I do see it as an issue, if the temp was 10 degrees above the setting but the feed rate was 0 that would be fine, I under stand about radiant heat. Now what I have happening, is the temp is set at 82 for both day and night but my temp actual temp on the coal-trol is going from 77-91, it just goes up and down all day/night long and I have had it hit 96 or above and it causes a high temp alarm. I had the coaltrol mounted on a wall near a corner, room is a U shaped room, out in front of the stove, I though maybe it was getting a daft from doors opening causing the temp to go low and the stove trying to boost the temp up. I have since moved the coal-trol to the wall on the side of the stove, the stove sits in a corner at a 45degree angle, and continue to have the same issue.
Example I just come home and the coal-trol is set for 82 and the room temp was 82, with in a half hour the room temp is now 92. Also every so often it will sound like the coal-trol has been unplugged, the fans slow down then come back up to speed. I have replaced the cable from the stove to the coal-trol unit with a brand new computer network cable as I though maybe the cable was bad, and that was the reason why it sounded as if the cable was unplugged and plugged back in.
I have been trying to be patient with this and get as much information about what is going on and also see if anyone else is experiencing this same issue.
Thank you for any info you may have.