Monometer part numbers

Monometer part numbers

PostBy: loxety On: Tue Apr 15, 2014 11:47 am

I took a picture of part #'s needed from home depot to add all metal parts to the flu in order to hook up a manometer (and not have it melt).

This gets the plastic parts about 1.5-2 ft away from any heat.
Attachments
Manometer parts.jpg
(107.32 KiB) Viewed 30 times
View: New PagePopup • Select:BBCode
[nepathumb]50891[/nepathumb]
Manometer parts connected.jpg
(88.74 KiB) Viewed 19 times
View: New PagePopup • Select:BBCode
[nepathumb]50892[/nepathumb]
loxety
 
Hand Fed Coal Stove: Harman Mark II
Coal Size/Type: Blaschak Nut

Re: Monometer part numbers

PostBy: McGiever On: Thu Apr 17, 2014 7:56 pm

I see a couple different brass fittings and small coil of soft copper tubing...Thanks for sharing. :)
McGiever
 
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hot Air Coal Stoker Stove: HARMAN MAGNUM
Hand Fed Coal Stove: RADIANT HOME AIR BLAST
Baseburners & Antiques: OUR GLENWOOD 111 BASEBURNER "1908"
Coal Size/Type: PEA / ANTHRACITE, NUT-STOVE / ANTHRACITE
Other Heating: Ground Source Heat Pump
Stove/Furnace Make: Hydro Heat /Mega Tek

Re: Manometer part numbers

PostBy: loxety On: Thu Apr 17, 2014 10:49 pm

there is a 90 degree fitting that bolts to the flue that has a compression fitting that goes to the straight copper tube then a compression fitting on the other end (coupler?) where the plastic tube connects from the manometer

I'll take some closer shots of the setup when I get the time :D
loxety
 
Hand Fed Coal Stove: Harman Mark II
Coal Size/Type: Blaschak Nut

Visit Hitzer Stoves

Visit Hitzer Stoves